Molotilo LLC
Decorate your life. Event design & styling.
Call: +1-202-865-6611
Customer Care representatives are available daily
from 9 a.m. to 5 p.m. PT


Build a bat house – boys life magazine

Home » Backyard Birds & Animals » Bat Boxes »

1вЃ„2″ x 30″ x 36″ sheet of exterior plywood (Don’t use pressure-treated plywood; it’s toxic.)

build a bat box

 

  • 1вЃ„2» x 26″ x 36″ sheet of exterior plywood
  • 1″ x 4″ x 40″ board for the roof
  • Two 1″ x 2″ x 24 1вЃ„2″ boards for interior frame

    1″ x 2″ x 36″ board for interior frame

  • Four 1″ x 2″ x 3″ wood spacer blocks
  • Crosscut saw
  • Pocketknife
  • One quart of dark exterior water-based stain
  • 53 1″ exterior wood screws
  • Seven 1 5вЃ„8″ exterior wood screws for the roof
  • Drill 1вЃ„2″ drill bit for vent holes
  • 3вЃ„32″ drill bit for screw pilot holes
  • Countersink bit so screws are flush
  • Phillips screwdriving bit
  • Two squeeze tubes of exterior, paintable caulking
  • One quart of exterior water-based primer
  • Two quarts of exterior black or gray water-based paint
  • Paintbrushes
  • WHAT YOU’LL DO
  • 1. Cut out all the bat house boards.
  • 2. Use your pocketknife to scribe shallow grooves (less than 1вЃ„16″ deep) across the inside of the back sheet of plywood, about 1вЃ„4″ to 1вЃ„2″ apart. These scored lines help bats grip the plywood.

    build bat house

     

    3. Run a bead of caulk onto the contact surfaces of the interior frame and spacer blocks. All surfaces that are in contact with each other should be caulked before screwing them together. The caulking acts as a gasket, sealing out water.

    build your own bat house

     

    4. Screw the interior frame and spacer blocks in place. Drill 1вЃ„2″ vent holes. In cold climates, you need only three or four vent holes. Stain the interior of the bat house, including the plywood, frame and spacer blocks. Allow the stain to dry.

    5. Caulk and screw the back panel to the frame and spacer blocks. Be sure to drill pilot holes to avoid splitting.

    6. Caulk and screw the roof on. A drop of caulking in each screw pilot hole will help waterproof the bat house and keep the inside dry.

    7. Paint the exterior with primer, then apply two coats of paint. Use black paint for colder climates and gray paint for warmer climates. Attach the bat house to a building or other structure. Face it south or east, about 10′ to 12′ off the ground.











    © 2016 | All Rights Reserved | www.molotilo.com